Question 3012 of 223 · California Water Treatment Operator Exam
Lubricating a motor bearing with too much grease can cause
Exactly one answer is correct.
You got of questions right. Here on the question pages nobody remembers which ones you got wrong. The trainer saves your progress and asks the mistakes again until they stick.
Or free: the 10 questions most people get wrong
Show solution
Correct answer to question 3012
- D: overheating and bearing failure
Explanation
Overgreasing causes churning, heat and seal damage. The correct amount and type of grease should follow the manufacturer's instructions.
More questions: Operation and Maintenance
- 3013What does an ammeter reading higher than the nameplate full-load amps on a pump motor suggest?
- 3014Lock-out/tag-out procedures must be followed before
- 3015A diaphragm metering pump is feeding too little chemical. A likely cause is
- 3016To calibrate a chemical feed pump, an operator would normally
- 3017A chemical feed pump is set to deliver 40 mL per minute. How many gallons per day is that? (1 gal = 3,785 mL)
- 3018Which of the following is a function of an anti-siphon (back pressure) valve on a chemical feed line?